Start
by opening an image of your choice. In this image we'll clone out the image
on the board and will replace it with our own image.
Select
clone stamp tool from the to0l palette.
Press
Alt and Click on blank area on board. This will define the source area.
Now
keep clicking on target area i.e. the face on board.
You
can change your source area any number of time by pressing Alt and clicking
on new area.
Keep
doing the above mentioned steps till you clone out the face completely.
Though
we are through with cloning still there are some patch mark. To remove these
patch marks we'll use healing brush tool. Select healing brush tool from
the tool palette.
Press
Alt and click to select source area and then click on patches left after
cloning
Repeat
the steps till you get rid of the patches completely.
NOw
you can easily insert your favorite image and place it over the board.
